How-to: read and write BMW X3 MSV90 DME using Xhorse Multi Prog programmer on bench.
Read ok, write OK, checksum by multi-prog.
 

  Problem:
I got error code 42 when decoding HU83 key blank with xhorse condor ii key cutting machine.
I have cleaned several times Also made calibration again Still same. Any advice?

 Here comes the Xhorse Dolphin XP005 (Generation 1) automotive key cutting machine maintenance manual.
 
This manual applies to models with serial number KM06, KM12 of Dolphin Generation I model.

Problem:
My friend has problems with the Xhorse dolphin xp005 key cutting machine. It’s not cutting b119 keys correctly. They look identical but only turn on door and not ignition.
 

Problem:
Anyone have problems with your machine decoding B106 key blank or any gm keys including old gm single side cut.? I can’t get my Triton or Xhorse Dolphin XP005 to decode them accurately? If I cut by code they work every ti...

 Problem:
I have vvdi mini Key tool and I use vvdi super chip XT27A with ID49 selected from ID49 Ford USA (They was malesia as well.. i choose USA) generates successfully but car/van doesnt wanna accept chip under programming immo.
Lon...

 Problem:
It is a BMW CAS3+ ISTAP. I was trying to get the ISN from the DME but I got a fail to connect message (Current CAS can’t update firmware via OBD).
however, the Xhorse VVDI BIMTool Pro can successfully read the DME informa...

 In my previous test, Xhorse VVDI PROG does not work with Volvo CEM TB28F400 microcircuits . It can erase them but cannot write. Now I’ve already have the next generation Xhorse Multi-Prog Programmer respectively. And the XDMPO4GL ...

 How to read Renault Megane 2 Scenic 2 UCH immobilizer data using Xhorse Multi Prog?
Quick search ‘uch’ and select Megane UCH
 

 Xhorse VVDI2 key programmer released new software version V7.3.6 on March 31st, 2024.
 
*** 2024-03-31

  Problem:
Failed to update xhorse multi prog firmware (Jump recovery error). The current firmware is 1.1.0. Also failed to sync device. Any solution?
 

 If you cannot turn on Xhorse Condor XC-Mini, Condor XC Mini Plus or Condor II key cutting machine, you may need to test the 24v voltage output of the battery to check if needs a battery replacement.